top of page
MAB-Watermaker Logotype

The automation module allows your MAB Watermaker to take care of itself. You get automatic start, stop and rinse, without having to be there. The system uses a float in the water tank that senses the levels and starts/stops the watermaker for you.

What the module does

  • Starts the watermaker when the tank level drops.

  • Stops production when the tank is full.

  • Performs automatic flushing after stopping.

  • Puts the system in “standby” mode until the tank needs to be refilled.

  • Protects the high-pressure housing from pressure surges through solenoid valves and bypass pressure relief.

  • Can be turned off at any time → then the MAB works as a regular, manual watermaker again.

What's included

  • Relay box with time relays for start delay, flushing and pressure relief.

  • Dump valve module with solenoid valves that handle flushing and pressure dumping.

  • Float sensor for installation in the water tank (start/stop control).

  • High pressure bypass hose and quick couplings for easy installation.

This is how it works in practice

  • The tank gets low → the float says "start".

  • The boost pump starts → the system builds up the correct working pressure.

  • The high-pressure pump starts automatically after about 10 seconds.

  • When the tank is full, production is shut down.

  • A timed flushing is run automatically (approx. 2 minutes).

  • The system goes into standby mode until the tank sinks again.

The entire cycle runs completely automatically.

MAB Automatik – make your MAB Watermaker fully automatic

SEK 14,495.00Price
Quantity
bottom of page